Trip Guardian™ 1503-TS-SPL Series Non-Magnetic Three-Axis Positioning Table
The 1503-TS-SPL Series outer axis (azimuth) can be positioned every 45° using the shot pin. The middle axis (inclination) has an engraved dial and a brake so the axis can be held in any position. The work surface is attached directly to the middle axis and provides a flat surface for mounting V-Blocks to allow cylindrical packages to be rotated about their own axes. Mounting surface dimensions: 6 inch diameter x 72 inches (152 x 1,829 mm), without V-blocks and 2.5 inch diameter X 74 inch long (64 x 1,880 mm) with V-blocks. Ovens also attach to the work surface to provide the capability to perform the testing over a large temperature range. The usable workspace inside the ovens is 4.6W x 72D x 6.7H inches (117W x 1,829D x 170H mm). Temperature heating is accomplished using silicone strip heaters. The workspace is covered by two ovens. Each oven has its own thermocouple and is controlled separately to minimize temperature gradients. The temperature controller is a dual-zone controller and can be configured to have separate set points or a single set point for the two zones.